Angled Joist Hangers – Full Flange (AJH10)
$29.00
Below are the available bulk discount rates for each individual item when you purchase a certain amount
- Buy 10 - 19 and get 10% off
- Buy 20 - 34 and get 12.5% off
- Buy 35 - 49 and get 15% off
- Buy 50 - 74 and get 17.5% off
- Buy 75 - 99 and get 20% off
- Buy 100 or above and get 22.5% off
If you're not quite sure about all your selections, don't worry, after you place your order, our experts will verify them and send you a CAD drawing of your product, with the dimensions you selected so you can put your eyes on it before we manufacture it for you. You can always call us at (715) 718-0781 if you want us to walk you through your order. The project will typically take between 2-3 weeks to manufacture. If you need to have them sooner please select "rush" when ordering.
(No reviews yet)
Write a Review
Angled Joist Hangers – Full Flange (AJH10)
Angled Joist Hangers With Full Flange
Here is an example of an angled joist hanger that has a full flange that works well for rafters and beams at an angle. These steel joist hangers are custom made to fit your joist or beam project perfectly. This is a very classy way to dress up your exposed beams or ceiling rafters. These are made to the pitch of your rafters. Providing your actual timber sizing will allow us to make the inside dimension 1/16" over so that you can easily slide the brackets on. If you want to have a super tight fit, just send us a note in your order when you check out and we will make them the size you selected. The flange width (part that mounts to the ledger or wall) and depth of the basket (distance from the wall or ledger) will be determined by the size of the beam.
Custom Angle, Hole Size, Thickness, and Finish Available on Beam Hangers
Angle, hole size, finish and thickness are things we can custom fit as well. Select the proper angle or pitch when ordering and we'll make them just right. When selecting, down angle means the basket will angle down, as if it were at the ridge beam and the joist angles down away from the ridge beam. Up angle would be the opposite side (the lowest side of the rafter). For left or right, pick the direction that you see it angling if you were to stand in front of it while it is mounted on a wall. If it comes out of the all and goes to the left, then select left. Opposite for right. To determine the hole size, just select the diameter of screws you will be using to install these and we will make the holes sufficiently large enough for them to fit just right. The holes may need to be offset for lag screw installation, depending on the ID of the basket holding the joist. If that is the case, we will automatically do that for you. Typically, if the joist is below 4"in width, we will offset the holes. If you want bolt-through on the basket, just put a note in the order when going through checkout to let us know. If you need a hand ordering these, just give us a call at (715)718-0781 and press one for a project advisor.Due to them not sitting on a shelf, they cannot be returned due to the wrong size being ordered. The project will typically take between 2-3 weeks to manufacture. If you need to have them sooner please select "rush" when ordering. We will get them out as soon as we possibly can.
